Order Products : sales@su-jiao.com

Shin-Etsu Elastomer KE-1950-40A/B

Category:	Silicone Rubber, HTV , Silicone Rubber, HTV
Manufacturer:	Shin-Etsu Silicones of America
Trademark:	Shin-Etsu Elastomer
Fillers:	-
Ports:	Qinzhou, Shekou, Shanghai, Ningbo
Delivery Terms	FOB, CIF, DAP, DAT, DDP
PDF:	i8YOyY_Shin-Etsu-Elastomer-KE-1950-40A-B.pdf
PRICE:	Order Products email sales@su-jiao.com

Wechat: WECHAT

Message
Shin-Etsu KE-1950-40 is a liquid injection molding silicone. It is supplied as two components which are mixed in a 1:1 ratio to ensure easy and accurate blending. The viscosity of KE-1950-40 is low enough to allow easy pumping through most injection molding systems. Fast cure rate for increased productivity. Curable over a wide range of temperatures. - No catalyst by-products. Typical Applications O-rings. - Diaphragms. Capping. Rubber rollers. Connector packings. Other electrical parts

Message

Shin-Etsu KE-1950-40 is a liquid injection molding silicone. It is supplied as two components which are mixed in a 1:1 ratio to ensure easy and accurate blending. The viscosity of KE-1950-40 is low enough to allow easy pumping through most injection molding systems.

Fast cure rate for increased productivity.

Curable over a wide range of temperatures. - No catalyst by-products.

Typical Applications

O-rings. - Diaphragms.

Capping.

Rubber rollers.

Connector packings.

Other electrical parts

General Information
Features	Low viscosity Workability, good Fast curing
Uses	Electrical/Electronic Applications Electrical components Diaphragm Roller Shield
Agency Ratings	FDA not rated USP Class VI
Forms	Liquid
Processing Method	Liquid Injection Molding (LIM)

Physical	Nominal Value	Unit
Specific Gravity	1.12	g/cm³

Hardness	Nominal Value	Unit
Durometer Hardness	42

Elastomers	Nominal Value	Unit
Tensile Stress (100% Strain)	1.01	MPa
Tensile Strength	9.80	MPa
Tensile Elongation (Break)	650	%
Tear Strength ¹	35.0	kN/m
Compression Set (180°C, 22 hr)	6.0	%

Thermoset	Nominal Value	Unit
Post Cure Time (200°C)	4.0	hr

Additional Information
Press Cure / Post Cure: Press/Post

Uncured Properties	Nominal Value	Unit
Curing Time	0.083	hr

Note Message
1 .	B mould

Resin Grade	Manufacturer	Category	Trademark
SABIC® PPcompound 8950	Saudi Basic Industries Corporation (SABIC)	PP, Unspecified	SABIC® PPcompound
Sarlink® TPE AB-2349DN	Teknor Apex Company	TPE	Sarlink® TPE
Diofan® A 299	Solvay Specialty Polymers	PVDC	Diofan®
ELASTOSIL® SOLAR 1109 BLACK	Wacker Chemie AG	Silicone	ELASTOSIL® SOLAR
Jam PE 484H2	Jam Petrochemical Company	HDPE	Jam PE