Order Products : sales@su-jiao.com

Addisil™ 6300

Category:	Silicone , Silicone
Manufacturer:	Momentive Performance Materials Inc.
Trademark:	Addisil™
Fillers:	-
Ports:	Qinzhou, Shekou, Shanghai, Ningbo
Delivery Terms	FOB, CIF, DAP, DAT, DDP
PDF:	77ISUu_Addisil-6300.pdf
PRICE:	Order Products email sales@su-jiao.com

Wechat: WECHAT

Message
Addisil 6300 silicone coating is a one-component heat curable silicone coating, which will bond to many substrates without a primer and which will cure rapidly at elevated temperatures. This product has a very long working time at room temperature and will not cure completely until exposed to elevated temperatures. Addisil 6300 is a white, flowable material, which can be applied on a textile by knife over roll. Compliance with FDA regulations Key Features and Benefits One component product - no mixing required Room temperature storage Fast cure at elevated temperature (in a range of 140 °C to 230 °C) Primerless adhesion to many types of substrates No formation of cure by-products Non-corrosive to metals Good performance over a wide temperature range

Message

Addisil 6300 silicone coating is a one-component heat curable silicone coating, which will bond to many substrates without a primer and which will cure rapidly at elevated temperatures. This product has a very long working time at room temperature and will not cure completely until exposed to elevated temperatures.

Addisil 6300 is a white, flowable material, which can be applied on a textile by knife over roll.

Compliance with FDA regulations

Key Features and Benefits

One component product - no mixing required

Room temperature storage

Fast cure at elevated temperature (in a range of 140 °C to 230 °C)

Primerless adhesion to many types of substrates

No formation of cure by-products

Non-corrosive to metals

Good performance over a wide temperature range

General Information
Features	Bondability Fast Cure Good Adhesion Good Flow Heat Cure Non-Corrosive
Uses	Coating Applications
Agency Ratings	FDA Unspecified Rating
Appearance	White

Thermoset	Nominal Value	Unit
Shelf Life (< 27°C)	> 17	wk

Uncured Properties	Nominal Value	Unit
Density	1.04	g/cm³
Viscosity (20°C)	30	Pa·s
Curing Time
200°C	8.3E-3	hr
175°C	< 0.033	hr
150°C	< 0.083	hr

Cured Properties	Nominal Value	Unit
Shore Hardness (Shore A)	30
Tensile Modulus (100% Secant)	0.600	MPa
Tensile Strength	6.00	MPa
Tensile Elongation at Break	300	%

Resin Grade	Manufacturer	Category	Trademark
SPESIN® KP213G15SI	Kolon Plastics, Inc.	PBT	SPESIN®
TECAMID™ MDS	Ensinger Inc.	Nylon 66	TECAMID™
Jamplast JP70G33	Jamplast, Inc.	Nylon 66	Jamplast
LUVOCOM® 1105-0699	Lehmann & Voss & Co.	PEEK	LUVOCOM®
MARPOL® HDM 507-UV	Marco Polo International, Inc.	HDPE	MARPOL®